INSTRUCTION MANUAL6" Edge Sander(Model 31-390, 391, 392)PART NO. 406-11-651-0006 - 03-12-02Copyright © 2002 Delta MachineryTo learn more about DE
STARTING AND STOPPING EDGESANDERTo start the tool, push the start button (A) Fig. 25; to stopthe tool, push stop button (B).ADJUSTING TABLE POSITIONTo
ADJUSTING LONG PLATENTo adjust the long platen when sanding on the straighttable:1. DISCONNECT TOOL FROM POWER SOURCE.2. Remove the top guard and dust
ADJUSTING BELT TRACKINGTo check and adjust the tracking of the sanding belt onthe pulleys, proceed as follows:1. Raise the dust chutes (A) Fig. 34, at
EDGE SANDINGWhen edge sanding, it is advisable to raise one end ofthe table as shown in Fig. 36. This allows cooler beltrunning, prevents spot wear, r
CHANGING SANDING BELTSTo remove and install sanding belts, proceed as follows:1.DISCONNECT TOOL FROM POWER SOURCE.2. The sanding belt can be changed w
15Two Year Limited WarrantyDelta will repair or replace, at its expense and at its option, any Delta machine, machine part, or machine accessory which
The following are trademarks of PORTER-CABLE·DELTA (Las siguientes son marcas registradas de PORTER-CABLE S.A.): BAMMER®,INNOVATION THAT WORKS®, JETST
2GENERAL SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain ha
ADDITIONAL SAFETY RULES FORABRASIVE FINISHING MACHINES1. DO NOT OPERATE THIS MACHINE UNTIL it isassembled and installed according to the instructions.
4POWER CONNECTIONSA separate electrical circuit should be used for your tools. This circuit should not be less than #12 wire and should beprotected wi
Fig. AFUNCTIONAL DESCRIPTIONFOREWORDDelta Model 31-390 is a large capacity Edge Sander for fast, efficient, straight and bevel edge sanding with the a
6ASSEMBLING LEGS TO EDGESANDERCarefully assemble the two support legs to the base ofthe edge sander as follows:1. Fasten each support leg (C) Fig. 3,
ASSEMBLING BELT TENSION LEVERAssemble the belt tension lever (A) Fig. 7, to thetensioning mechanism by threading the end of lever (B)into the tapped h
ASSEMBLING AUXILIARY ABRASIVEDRUM AND SPINDLE ASSEMBLY TODRIVE PULLEYThe auxiliary abrasive drum and spindle assembly isfurnished as standard equipmen
ASSEMBLING AUXILIARY END TABLEASSEMBLYThe auxiliary end table is furnished as standard equip-ment with the edge sander. The table is used whenperformi
Komentarze do niniejszej Instrukcji