INSTRUCTION MANUAL14" Floor DrillPressPART NO. 1046995© Delta Machinery International Machinery Corp. 1995MODEL 14-070Dated 6-30-95
1. Drill two 3/8" diameter holes (C) Fig. 12B, correspon-ding to the mounting holes (A) Fig. 12A, of the drill press basein a 21" by 28"
CAUTION: THIS TOOL MUST BE GROUNDED WHILE IN USE TO PROTECT THE OPERATOR FROM ELECTRICSHOCK.In the event of a malfunction or breakdown, grounding prov
SPINDLE SPEEDSTwelve spindle speeds of 250, 360, 410, 540, 590, 650,1090, 1280, 1450, 1820, 2180 and 3000 RPM are avail-able with the 14" Drill P
CHANGING SPINDLE SPEEDSAND ADJUSTING BELT TENSION1. DISCONNECT THE DRILL PRESS FROM THE POWER SOURCE.2. Lift up belt and pulley guard (A) Fig. 16.3. L
SWITCHThe switch (A) Fig. 17, is located on the front of the drillpress head. To turn the drill press “ON” move the switchto the up position. To turn
3. The table can be tilted right or left by pulling out andremoving table alignment pin (C) Fig. 20, and loosening table lock-ing bolt (D). NOTE: If p
DRILLING HOLESTO DEPTHWhere a number of holes are to be drilled to exactly thesame depth, a depth stop is provided in the pinion shafthousing and is u
OPERATIONYour drill press is to be used with drill bits of 5/8" or less indiameter. The following directions will give the inexperi-enced operato
Two Year Limited WarrantyDelta MachineryDelta will repair or replace, at its expense and at its option, any Delta machine, machine part, ormachine acc
TABLE OF CONTENTSSAFETY RULES 3ADDITIONAL SAFETY RULES FOR DRILL PRESSES 4UNPACKING 5CLEANING 6ASSEMBLY INSTRUCTIONS 6-9FASTENING DRILL PRESS TO A SUP
Woodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain hazards involved with t
ADDITIONAL SAFETY RULESFOR DRILL PRESSES1. WARNING: DO NOT operate your drill press until it iscompletely assembled and installed according to theinst
UNPACKINGCarefully unpack the drill press and all loose items from the carton. Figure 2 illustrates the drill press and all loose itemssupplied with t
CLEANINGRemove the protective coating from the machined surfaces of the drill press and all loose items. This coating may beremoved with a soft cloth
4. Insert raising rack (E) Fig. 5, which was removedin STEP 2, into groove in table bracket (H) makingsure gear inside table bracket is engaged with t
7. Assemble table raising and lowering handle (M) Fig.8, to shaft on table bracket and tighten set screw in han-dle against flat on shaft.8. Thread ta
11. IMPORTANT: Make certain the bottom ofspindle (S) Fig. 11, and tapered hole (T) in chuckare clean and free of any grease, lacquer or rustpreventive
Komentarze do niniejszej Instrukcji