Delta 37-380 Instrukcja Obsługi Pobierz pdf (Strona 12)

2. Fig. 18 illustrates fence properly mounted.

Fig. 18

3. Thread shorter fence handle (E ) Fig.19, into infeed

end of fence (A) and longer fence handle (G) into outfeed

end as shown.

Fig. 19

ASSEMBLING

CUTTERHEAD GUARD

1. Remove set screw (not shown) from cutterhead

guard post (F) with the 2.5mm hex wrench. Insert post

(F) through hole in the infeed table. NOTE: A spring is

supplied in knob assembly (E) that returns the guard (C)

over the cutterhead after a cut has been made. Turn

knob (E) counter-clockwise to provide tension on the

spring before inserting post (F). Make certain the spring

engages in the slot of the post. If spring tension is too

tight or too loose, adjust the spring accordingly by

removing the guard and rotating knob (E).

2. Thread set screw (B) Fig. 21 back into post (F) Fig.

20, to keep cutterhead guard (C) in position during

jointer operation.

3. Fig. 21, illustrates the cutterhead guard (C)

assembled to the infeed table.

Fig. 20

Fig. 21

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Brak uwag

Delta 37-380 Instrukcja Obsługi Strona 12