Delta 70-200 Instrukcja Użytkownika Strona 1

INSTRUCTION MANUAL20" Drill Press(Model 70-200)PART NO. 900615 (0012)Copyright © 2000 Delta MachineryESPAÑOL: PÁGINA 17To learn more about DELTA

10Fig. 16FASTENING DRILL PRESS BASETO A SUPPORTING SURFACEFig. 17Fig. 18PERMANENT MOUNTINGIf your drill press is to be used in one permanent loca-tion

11OPERATING CONTROLS AND ADJUSTMENTSFig. 23START/STOP SWITCHThe switch is located on the front of the drill press head.To start the machine, press the

12Fig. 27Fig. 28Fig. 29Fig. 30DRILLING HOLES TO DEPTHWhere a number of holes are to be drilled to exactly thesame depth, a depth stop is provided in t

13Fig. 31OPERATIONYour Drill Press should be used with drill bits 5/8 or less in diameter.The following directions will give the inexperienced operato

14DRILLING METALUse clamps to hold the work when drilling in metal. The work should never be held in the bare hand;the lips of the drill may seize the

NOTES

Delta Building Trades and Home Shop MachineryTwo Year Limited WarrantyDelta will repair or replace, at its expense and at its option, any Delta machin

The following are trademarks of PORTER-CABLE DELTA Corporation (Las siguientes son marcas registradas de PORTER-CABLE S.A.):BAMMER®, INNOVATION THAT W

2SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, there are certainhazards in

3ADDITIONAL SAFETY RULESFOR DRILL PRESSES1. DO NOT operate your drill press until it is complete-ly assembled and installed according to the instructi

4CONNECTING DRILL PRESS TO POWER SOURCEPOWER CONNECTIONSA separate electrical circuit should be used for your tools. This circuit should not be less t

Fig. AFig. BGROUNDED OUTLET BOXCURRENTCARRYINGPRONGSGROUNDING BLADEIS LONGEST OF THE 3 BLADESGROUNDED OUTLET BOXADAPTERUse proper extension cords. Mak

6UNPACKING AND CLEANINGCarefully unpack the drill press and all loose items from the carton. Remove the protective coating from themachined surfaces o

7Fig. 43. Assemble worm gear (J) Fig. 4, to the inside of hole(K) in table bracket (H).4. Thread table lock lever (M) Fig. 4, into hole in tablebracke

88. Reassemble collar (D) Fig. 7, which was removed inSTEP 1, to column. IMPORTANT: Bottom of collar (D)MUST NOT be pushed all the way down onto top o

9Fig. 1111. Place the drill press head on column, as shown. Lineup head with base and tighten two head locking screws(R) Fig. 11.12. Thread the three