Delta 43-290C Instrukcja Obsługi

A Pentair CompanyTo learn more about DELTA MACHINERYvisit our website at: www.deltamachinery.com.For Parts, Service, Warranty or other Assistance,plea

10Fig. 18Fig. 19GROUNDED OUTLET BOXCURRENTCARRYINGPRONGSGROUNDING BLADE ISTHE LONGEST OF THE 3 BLADESGROUNDED OUTLET BOXGROUNDING BLADE ISTHE LONGEST

11Extension CordsMake sure your extension cord is in good condition an is a 3-wire extension cord which has a 3-prong grounding type plugand matching

12OPERATING CONTROLS AND ADJUSTMENTSChanging Speeds and Adjusting BeltTensionDISCONNECT TOOL FROM POWER SOURCE.Figure 23The shaper is supplied with a

13Fence Controls and AdjustmentsDISCONNECT TOOL FROM POWER SOURCE.Figure 24The fence halves (A) should be adjusted so that the openingat the spindle i

14Fig. 26OPERATIONSShaping When using the Fence as aGuideThe use of the fence is the safest and mostsatisfactory method of shaping. Most straight work

15ACCESSORIESA complete line of accessories is available form your Delta Supplier, Porter-Cable • Delta Factory Service Centers, andDelta Authorized S

Two Year Limited WarrantyDelta will repair or replace, at its expense and at its option, any Delta machine,machine part, or machine accessory which in

2TABLE OF CONTENTSSAFETY INSTRUCTIONS ... 3,4UNPACKING MACHINE... 4,5A

3SAFETY RULESWoodworking can be dangerous if safe and properoperating procedures are not followed. As with all machinery,there are certain hazards inv

4ADDITIONAL SAFETY RULES FOR WOOD SHAPERSWARNING: DO NOT OPERATE YOUR WOOD SHAPER UNTIL IT IS COMPLETELY ASSEMBLED ANDINSTALLED ACCORDING TO THE INSTR

5Figure 3The following shaper parts require assembly. Please be sure all of the listed parts are included before starting assembly.Fig. 31. Center Gua

6ASSEMBLY INSTRUCTIONSWARNING: FOR YOUR OWN SAFETY, DO NOT PLUG SHAPER IN OUTLET UNTIL THE TOOL ISCOMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE

7Assembling and Attaching FenceFigure 7The fence for this shaper can be mounted in two positions.Forward, using the two front fence mount holes (A), o

8Fig. 11Assembling and Changing SpindlesDISCONNECT TOOL FROM POWER SOURCE.Figure 11Thread the end of the tie rod with the shorter threads (A)into the

9Fig. 14Stock Guide Assembly and PositioningFigure 14Slide two guide brackets (A) onto a guide assembly rod (B).Thread two allen lock screws(C) into t